Wiper arms & blades

Front Page Forums PaNNTOA Forum Maintenance Wiper arms & blades

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #14219
    Bob Tilley
    Participant

    2001 with old style arm & blades held on by small bolt & nut.  There’s a reply frm factory but it covers the articulating arm (wit 2nd smaller arm).  Any suggestion on replacement?  The arm springs are weak & rubber on blades hard

    Westin Merrit  Bob Tilley Port Townsend 360 531 1322

    #14220
    Carmen
    Participant

    When I bought my 2000 last year the arms were similar to what describe.  I haven’t sourced replacements yet but I got them working like the should by spraying Kroil in the hinge points and working them to loosen up.  Then applied lube to springs and pivot points and they are much better.  Haven’t looked for blades yet.  I also found the clamp bolts frozen and need to see if I can get them loosened if I end up replacing the arms.

    #14221
    Bob Tilley
    Participant

    Thnk u.  Same thought  & might try someting like 303 rubber restorer’s on the blades. Nordic

    factory has an old article but not old enough, parts list for articulating double arm blades.

    #14233
    Paul Bulk
    Participant

    I have a 2001 32 and I got new arms from Trotac marine up here in Victoria (mine broke when trying to get it to move freely). It was an adjustable length arm and they sell the blades too. The arm was $40

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.